Insights

Why Sleeves Go In Before the Pour

A new driveway seals the ground between the house, the yard and the street for decades. An empty pipe laid across the trench first costs almost nothing, and it is the only easy way to get anything to the other side afterwards.

A driveway usually runs straight across the line between the house and everything else on the lot: the front beds, the lamp post, the mailbox, a detached garage or a shed on the far side. Once it is poured, anything that needs to reach those places has to go around it, under it, or through it. Around it is often a long way. Under it, without preparation, means hiring someone to bore beneath the slab and hoping they miss the base. Through it means sawing up a surface you have just paid for. When we plan a concrete driveway, the question of sleeves comes up before the forms go in, because it is the one decision that cannot be revisited cheaply.

What a sleeve is, and what it is not

A sleeve is just a length of empty pipe laid across the excavation, below where the base and slab will be, with its two ends left reachable on either side. It is not wiring and it is not plumbing. It is a reserved route. The electrician, the irrigation installer or whoever needs to cross later pushes their line through it instead of digging.

Laying one takes a few minutes while the ground is open. The pipe itself is cheap. The value comes entirely from timing, which is why this is the kind of detail worth raising at the estimate rather than on the morning of the pour.

What people most often wish they had run

The usual candidates are these:

  • Lighting along the drive or at its end. A post light by the street, a low light at a bend, fixtures on a gate pier. The zoning code allows yard lighting in any yard as long as it points down and is shielded from neighbours and the road, so the question is only how the power gets there.
  • Power or data to an outbuilding. A detached garage, workshop or shed on the far side of the drive, now or later.
  • Water to the front beds. An irrigation line or a hose bib on the other side of the drive from the house tap.
  • Something for a car parked outside. If vehicles live on the drive rather than in the garage, a future charging point by the parking spot needs a route from the panel.
  • A heated section. Anyone weighing snow-melt needs controls and sensor wiring, and the cost side of that is set out in what a heated driveway costs.

You do not have to be sure you will want any of these. The rule we suggest is simple: if the honest answer is "maybe one day", lay the pipe.

Where the crossings go

Position matters more than quantity. Two sleeves in the right places are worth more than five in the wrong ones.

Near the garage end. This is where the house, the panel and the outside taps are. A crossing here serves anything on the far side of the drive from the house.

Near the street end, but on your land. Lighting at the entrance and a mailbox post both sit out here. Keep the crossing inside your property line, though. The last stretch of the drive lies in the public right-of-way, built to the Village detail under the Village's own permit, and whatever is buried in it is the Village's concern first. The zoning code lets a mailbox stand in the right-of-way; that is not the same as permission to lay lines there.

Where the ends can be reached. A sleeve whose end finishes under a new patio or a row of shrubs is a sleeve nobody can use. Bring both ends out into soft ground, or into a bed you are prepared to dig.

Village ruleWhat it allowsWhat it means for sleeves
Yard and service lightingAny yard, aimed downward and shieldedLighting is a realistic future use; plan a route
Ornamental lights and similar features5 ft from any lot line, outside the vision triangleBrings the sleeve end in from the boundary
MailboxesMay stand in the road right-of-wayThe box may be public ground; the sleeve stays private

Depth is the electrician's call

The one number people ask us for is depth, and it is the one we will not give. How deep a cable has to be buried depends on the type of cable and the pipe around it, and the electrical code sets it, not the concrete. If a sleeve is likely to carry power, ask the electrician who will eventually use it where it should sit, and do it before the base is placed. A sleeve laid too shallow for its purpose is a pipe nobody is allowed to use.

The same goes for size and material. A water line and a lighting cable want different things. Settle what might go through each one, and let the trade that will use it choose the pipe.

Recording it, because nobody else will

When the utility locate is called before any dig, the marks cover public utility lines. Private lines you have added are nobody's to mark, which is covered in more detail in our note on the locate call. An empty sleeve is a private line, and five years from now its only map is whatever you kept.

  • Photograph each sleeve in the trench with a tape measure in the shot.
  • Measure each end from two fixed corners of the house or garage.
  • Leave a pull string inside and cap both ends so soil stays out.
  • Keep the notes with the house papers, not on a phone that will be replaced.

The same logic applies to a patio

Anywhere concrete is about to cover a route between two useful places, the same question applies. A new patio between the house and the far end of the garden deserves the same thought before it is poured.

If you are replacing a drive, bring the list of maybes to the estimate. We will mark where sleeves make sense on the layout for your concrete driveway, leave room for the trades who will use them, and keep them clear of the part the Village owns.

Sources

  1. Village of Pleasant Prairie Code, s. 420-139(B)(1)(o), (p) and (u) - ornamental lights and similar features, mailboxes in the right-of-way, and the shielding rule for yard lighting. Read 28 September 2026.

Book a Site Visit

Get your free, on-site quote.

Tell us about your project and we'll call you back the same day to set up a free measure and price.

Get your free quote

Tell us about your project and we will call you back the same day. No obligation.

What are you looking to do?
Roughly how big?
When are you thinking?

Pricing it out is fine. We will not chase you.

What is your ZIP code?

So we can confirm you are in the service area.

Where should we send it?

Free, no-pressure quote · Serving Kenosha County, WI

By submitting, you agree to our Privacy Policy and Terms, and consent to be contacted by phone, text, or email about your project, including by automated means. Consent isn't a condition of purchase. Msg & data rates may apply.

Call (262) 228-5293 Text us