Cost
What a Heated Driveway Costs
A snow-melt drive is really two purchases stacked in one trench: a heating system from one trade and a slab from another. Here are the published figures for both, what it costs to run each winter, and why the choice cannot wait until after the concrete is down.
Every November somebody asks whether it is worth heating the drive this time. It is a fair question in a place where the drive gets cleared many times between December and March, and it usually comes up when a driveway is due for replacement anyway, which is exactly the right moment to ask. The answer turns on a few numbers that national guides publish and a couple of practical points they do not. Our concrete driveway work covers the slab; the heating itself is somebody else's trade, and a fair price comparison keeps the two separate.
The headline figures
These come from HomeGuide's heated driveway guide, which is built from project costs its members report. They are national, they mix regions with very different labour rates, and they are for new paving with the heat laid underneath.
| What is priced | HomeGuide figure |
|---|---|
| Heated concrete, installed, per sq ft | $13 to $28 |
| The same concrete with no heat, per sq ft | $6 to $15 |
| One-car drive, 12 by 24 ft (288 sq ft) | $3,400 to $8,000 |
| Two-car drive, 24 by 24 ft (576 sq ft) | $6,900 to $16,000 |
| Three-car drive, 36 by 24 ft (864 sq ft) | $10,000 to $24,000 |
| Heated concrete, two-car, before any tear-out | $6,500 to $17,000 |
The comparison worth making is the first two rows. Heating roughly doubles what the surface costs per foot. On a short suburban drive that is a sum many owners can weigh; on a long rural lane west of the interstate it multiplies fast, which is why the partial options further down exist.
Note that the size rows treat a two-car drive as a square pad. Most drives here are a pad at the garage plus a run to the street, so measure yours rather than picking the nearest row.
Where the money actually goes
HomeGuide also splits the total into its parts, and the split is the most useful thing on the page, because it shows how little of the bill is concrete.
| Line | Published range |
|---|---|
| Breaking out the old drive | $1 to $3 per sq ft |
| Heating system itself | $9 to $20 per sq ft |
| New concrete or asphalt over it | $3 to $8 per sq ft |
| Automatic sensor and controller | $500 to $3,500 on top |
| Dedicated boiler (hydronic) | $3,200 to $9,000 |
| Panel upgrade to 400 amps (electric, if needed) | $2,000 to $4,000 |
The heating line is the largest by a distance, and it belongs to a licensed electrical, plumbing or mechanical contractor, not to a concrete crew. HomeGuide notes that the system warranty generally depends on a licensed installer on the heating side and a licensed paving contractor on the surface. In practice that means two contracts, two schedules and one slab that both depend on, so ask each party exactly where their work stops.
Electric cable or hot-water tubing
There are two ways to warm a slab from below. Electric systems lay a grid of heating cable in or under the concrete. They are simpler and cheaper to put in and warm up faster, but they want dedicated circuits, sometimes a bigger service panel, and they stop when the power does, which in an ice storm is not a small point.
Hydronic systems pump a warmed mix of water and antifreeze through plastic tubing. They cost more up front, need a boiler of their own rather than borrowing the house's, and need somewhere indoors to put it. In exchange they are usually cheaper to run.
| Running cost, 1,000 sq ft heated | Per winter, HomeGuide |
|---|---|
| Any system | $120 to $600 |
| Hydronic | $120 to $250 |
| Electric | $250 to $600 |
| For comparison: a seasonal plowing contract | $200 to $600 |
That last row is the honest check on payback. A heated drive does not pay for itself against a plowing contract in any reasonable span; the operating cost alone can match what a plow service charges. People who are glad they did it bought it for other reasons.
Heating only where the tyres run
The standard way to cut both bills is to heat two strips, each about 24 inches wide, running the length of the drive under the wheel paths, and leave the rest cold. Cars get bare concrete to drive on and the snow between the strips is cleared by hand or left. It is the same logic as a ribbon driveway, applied underneath a full-width slab. Heating by zones, one section at a time, is another option that can avoid a panel upgrade at the cost of slower melting.
Why it has to be decided before the pour
An existing drive can take heat only one way: grooves are cut into the surface, electric cable goes in and the grooves are filled. HomeGuide prices that retrofit at $7 to $17 a square foot, and it comes with a catch. There is no insulation under an old slab, and the guide reports that without one to two inches of foam board beneath the heating, more than half the heat goes down into the ground rather than up into the snow.
Hydronic cannot be retrofitted at all. So if a replacement is coming anyway, the base, insulation and heating layer all have to be designed together before anything is poured, and a heated drive decided later is a worse system at a higher running cost.
Meltwater also has to go somewhere. Snow melted in place becomes water on the slab, and water that sits refreezes the moment the system switches off. The fall of the drive matters more on a heated slab than an ordinary one, a subject covered in our note on driveway slope.
The end at the street
The last stretch of a Pleasant Prairie drive, between your property line and the road, is in the public right-of-way. It is built to the Village detail, under a permit, by a contractor who carries the Village's licence and cover. Burying a heating loop in it is a question for the Village before it is a design choice, and the simplest answer is to stop the heated area at the line. The rules for that stretch are gathered on the approach rules page.
Who it is worth it for
The owners we would expect to be glad of it have a steep drive that turns treacherous, somebody in the house for whom a slip would be serious, or a drive long enough that clearing it is a morning's work. For a level two-car pad a good snowblower wins on money every time, and there is no shame in that answer.
If a replacement is on the calendar and you want the slab priced with or without heat, book a site visit for your concrete driveway and bring the heating question with you. We will tell you what the concrete side involves, and point you to the separate trade for the rest.
Sources
- HomeGuide, How much does a heated driveway cost? - installed cost per square foot and by drive size, the cost split by line, sensors, boiler and panel costs, running cost by system type, plowing contracts, retrofit pricing, tire-track heating and insulation. Page dated 27 May 2025, read 28 September 2026.