Cost
What a Circular Driveway Costs
A loop is two things priced as one: a curved ribbon of concrete across your front yard, and two separate connections to a public street. Here is what each half is published at, and what the Village decides before a price means anything.
People who ask about a circular drive usually have a picture already: the car pulls in at one end, sweeps past the front door and leaves at the other without ever reversing. It is a good picture. It is also a more complicated job than its outline suggests, because the curve costs more per foot than a straight run, and each end is a separate piece of work on ground you do not own. Anyone quoting a loop as a single square-foot figure has left something out. Our concrete driveway work covers both halves, and this page pulls them apart so you can see where the money actually goes.
What the national guides publish
HomeGuide is the only national cost guide we found that prices a loop specifically, so these come from its driveway guide. They cover every paving material, not concrete alone, and they are averages drawn from across the country rather than quotes for a street in this Village.
| Item | Published range |
|---|---|
| Loop 50 ft across, about 1,650 sq ft | $5,000 to $15,000 |
| Curved layout against a straight one | 10% to 20% extra |
| New driveway, any material | $3 to $12 a sq ft |
| Concrete in the by-material table | $4 to $8 a sq ft |
| Labour share of the total | About half |
| Excavation of plants and soil | $1 to $5 a sq ft |
| Grading and base preparation | $5 to $8 a sq ft |
| Drainage trench or channel | $400 to $2,400 |
| Decorative curbing along an edge | $5 to $18 a linear ft |
Read the first row with care. A loop fifty feet in diameter is a modest one, and the spread between its low and high figure is threefold, which tells you how much depends on the ground and the material rather than the outline. On a lot where the front yard has to be dug out, levelled and given a proper stone base, the site preparation rows can rival the concrete itself.
Why the curve carries a premium
The ten to twenty percent is not a markup for looks. It is time. Straight forms go down in long boards; curved ones are bent, staked at short intervals and checked repeatedly, and every foot of curved edge is finished by hand. A ring also has two long edges for the area it covers, inside and outside, where a rectangle of the same size has far less perimeter. Edges are where the labour is.
Since labour is roughly half of any driveway bill, a layout that slows the crew down shows up in the total quickly. That is why a tighter, simpler loop is not always proportionally cheaper: some of the cost is in the shape, not the size.
Working out your own area before anybody quotes
You can get close with a tape and some string. Lay a hose along where the centre of the lane would run, measure its length, and multiply by the lane width you want. Say the centreline comes out at 110 feet and you want a lane 12 feet wide: that is 1,320 square feet before the two connections and any parking bay you add beside the front door.
Two things change that arithmetic in practice. The inside of the curve is shorter than the outside, so a wide lane on a tight curve wastes less than you would expect but turns worse than you would hope; test it with your largest vehicle and some marker cones. And the straight legs that meet the street are rarely where people imagine them, for reasons the Village sets out.
The two ends are governed separately
This is the part a loop drawn on a napkin misses. Every loop needs two openings onto the road, and in Pleasant Prairie a second opening is a permission question before it is a price question. The rules that shape where those openings go, from the zoning code and the Village street detail:
| Rule | What it says | Why it matters for a loop |
|---|---|---|
| Second opening, Village road | Zoning Administrator may approve; centrelines at least 55 ft apart | Sets the minimum spread of the two legs |
| Arterial road | One driveway only | A loop onto an arterial is off the table |
| Near an intersection | No access within 100 ft of a Village road intersection, 150 ft of an arterial one | Corner lots may not fit two openings |
| Side lot line | Drive at least 5 ft away | Narrows the usable frontage |
| Width at the property line | 12 ft minimum, 24 ft maximum | Applies to each leg |
| Angle in the right-of-way | Perpendicular to the road centreline unless the Village approves | The sweep starts on your side of the line |
| Concrete in the right-of-way | 6 in on a 6 in gravel base | Thicker than the slab on your own land |
| Public sidewalk at a crossing | Removed and replaced to the nearest joint | Two crossings, two sidewalk repairs |
Put those together and a pattern emerges. On a narrow lot, the fifty-five foot spacing plus the setbacks at each side can use up most of the frontage, and the loop either fits with room to spare or does not fit at all. On a corner lot, the intersection distances may rule out the second opening entirely. It is worth measuring your frontage before you fall in love with the idea.
The thickness row is a cost point, not just a spec. Inside the right-of-way the Village wants six inches of concrete where a residential slab on private ground starts at four, which is half as much concrete again per square foot in each apron. With two aprons, plus the public walk replaced at each crossing, the street end of a loop can cost noticeably more than the same area in the middle of your yard.
Where not to spend the decorative money
A loop across the front of the house is exactly where people want a stamped border or a coloured finish, and on your own land that is a reasonable choice. The Village detail is blunt about the public end, though: if it ever needs to take out a driveway or apron in the right-of-way, it puts back plain broom-finished concrete, asphalt or gravel, regardless of what was there. The practical answer is a plain apron at each leg and whatever finish you like from the property line inward.
Asking for a price you can compare
Loop quotes are hard to line up against each other because each bidder bundles differently. Ask each one to break the job into the same lines:
- The loop itself, on your land, by area and thickness.
- Each apron in the right-of-way, separately.
- Any public sidewalk sections replaced at the crossings.
- Excavation, grading and base, as their own line.
- Who applies for the second opening, and what happens to the price if it is refused.
That last line is the one that separates bidders. Somebody who has built loops here will know the second opening needs approval and will say so before pricing anything.
If the permission is the sticking point, the case for a single entrance with a turning area is made in our look at whether a second entrance pays, and the full set of street-end rules is on the approach rules page. When you have a layout you like, the next step is a site visit for your concrete driveway, where we walk the frontage with a tape before anything is drawn.
Sources
- HomeGuide, How Much Does a Driveway Cost? - the circular driveway row and curved-layout premium, per-square-foot ranges by material, labour share, excavation, grading, drainage and curbing. Page dated 19 December 2025, read 24 September 2026.
- Village of Pleasant Prairie Code, s. 420-46 - number of driveways, spacing between openings and from intersections, side setback and width. Read 24 September 2026.
- Village of Pleasant Prairie Code, Ch. 305, Attachment 3 (detail RD-12) - thickness and base in the right-of-way, sidewalk replacement at crossings, perpendicular alignment and the Village's replacement finish. Read 24 September 2026.